
Countertop Cooking equipment
OperatOr’s Manual
5. Tilt the oven door (B) up slightly and lift the oven door out.
6. Door (B) may be cleaned.
7. Using a damp cloth, sponge dipped in soapy water to clean the door
(B).
8. Use towels to completely dry the door (B) or allow it to air dry
completely.
9. Carefully set the oven door (B) into the oven (A). Place the arm (D) so
that it sets under pin (C). See Figure 6.
10. Rotate the hinge lock (E) off the hinge arm (D) as shown. Repeat on
both sides. See Figure 4.
11. Carefully open and close the door to verify that it is operating correctly.
If not repeat steps 4 and 5.
maintenance
Replacement of the oven light.
1. Turn off and unplug the equipment.
2. Allow the equipment to cool completely before cleaning.
3. Unscrew the light cover.
4. Remove and discard the old light.
5. Install a new light. The new light must be rated for the high
temperature and must match the nameplate voltage.
40703, Mini Prima Pro, 120 Volt - 15 watts
40701, Prima Pro, 220 Volt - 25 watts
40702, Proton, 220 Volt - 25 watts
6. Install the light cover.
To remove and install the oven door:
1. Allow the equipment to cool completely before removing the door.
2. Open the door (B). See Figure 4.
3. Note the down or back position of hinge locks (E). Check that both sides
are in this position.
4. Place the hinge lock (E) over the hinge arm (D) as shown. Repeat on both
sides. See Figure 5.
troubleshooting
Pilot Light does not come on when the temperature
control is turned up.
The equipment is not plugged in. Plug equipment in.
Pilot Light malfunction. Replace Pilot Light.
Thermostat Control malfunction. Replace Thermostat Control.
The light comes on, equipment does not heat. Heating Element malfunction. Replace Heating Element.
Brown function does not work. Bake Control not set to brown setting. Set Bake Control to brown setting.
Mist function does not operate. Blocked or no water supply. Turn water supply on or clean blockage.
Komentáře k této Příručce